ExpiredSMOK TFV12 Cloud Beast King (4 colours) – £23.93
4 COLORS FOR YOU
SPECIFICATIONS
V12 ENGINE
KING’S SWORD
STAINLESS STEEL & GLASS MATERIAL
KING’S ARMOR
It is larger, stronger and crazier. The large size V12-T12, V12-X4 and V12-Q4 coil
heads improve the efficiency of atomization, and compati ble with various mods
with high output power. The powerful coil heads for the best tank, it is the sword
from the king which makes anything possible.
LARGE CAPACITY
KING’S BROAD-MINDED
TFV12 features with large size and 6ml e-juice capacity, which can satisfy several
times vaping. TFV12 is just like the true king that is capable with anything.
TFV12 VS TFV8
THE BEAUTY OF EVOLUTION
The evolution of the TFV series has always brought you a bigger better Beast with each release. The
TFV12 is no different. The TFV12 has had it’s diameter increased by 2.5mm, it’s airflow inlets have
been increased by 30%, a larger inner diameter Delrin drip tip, all of which increase the TFV12’s
performance. You will love the King of Beast’s roar!
SPECIAL GLASS MATERIAL DRIP TIP
（ OPTIONAL）
TOP REFILL SYSTEM
Top rotary refill design makes filling as easy as it gets. Leak proof e-liquid slot can
significantly solve leaking problem.
SUPPORT SINGLE COIL BUILD
It supports single coil build when used with the silicone pad.
V12-RBA-T supports single coil build
RBA BUILDING
Before starting make sure your hands are clean.
Taking RBA apart.
Installing the pre-wrapped coil.
Place the coil between the posts and wrap the ends around the screws and tighten
up, once all in place make sure the coil is fixed in the center and lined up with the
air hole, and also make sure the coil is NOT touching the base.
Position and cut the ends of wire off.
Cut a strip of cotton and make sure it’s not too much, and not too little.
Insert the cotton, and place it in the middle
Cut the cotton at an angle. Make sure it’s not too short and not too long.
Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device,
and re-checked periodically to ensure the resistance remains the same.
RBA-T BUILDING
Before starting make sure your hands are clean.
Taking RBA-T apart.
Position and cut the ends of wire off.
Cut a strip of cotton and make sure it’s not too much, and not too little
Insert the cotton, and place it in the middle
Cut the cotton at an angle. Make sure it’s not too short and not too long.
